|
|
| Chemicals |
|
|
| WINTER PRODUCTS |
|
|
 Winterize the right way with Winter Care! Winter can be tough on pool. Algae and
other problems can start even in cold weather, making spring opening messy and
expensive. Prevent these problems now by winterizing your pool properly and using
WinterCare closing products. WinterCare products are designed to keep your pool water
clean and clear all winter long.
Proper winterization also protects pool surfaces and equipment, and makes spring start-up
quick and easy. Keep in mind, proper winterization involves more than just adding products.
Follow the steps below to make sure you pool is well protected through the cold weather
months.
1. Balance the pool water.
Take a sample of your pool water to your local Guardex dealer for expert advice on water
balance. If needed, adjust the pH to 7.4 - 7.6 and make sure the other balance factors are in
their proper range.
2. Winter Cleaning
Brush all pool walls and bottom and vacuum if needed. Clean along the waterline and around
pool surfaces with an appropriate pool surface cleaner. Also clean out the skimmer and hair
and lint trap. Backwash your filter and use a chemical cleaner to remove oils and grease and
ensure proper operation.
3. Add Winter Care products
Add Winter Shock to your pool at a rate of 1 lb per 10,000 gallons. Scatter the product
evenly over the pool surface. Winter Shock should dissolve completely when added but use
your pool brush to mix up any product that settles to the bottom. If the pool water is already
cold (below 60 degrees) you should predissolve this product before adding to water.
Predissolve Winter Shock by adding 1 lb of shock to 2-3 gallons of water. Mix thoroughly
and then add evenly across pool surface. Add Winter Algaecide to the pool at a rate of 1 pint
per 10,000 gallons or 1 quart per 20,000 gallons. Apply product around the edges of the
pool. Use the pool pump to distribute these products evenly throughout the water.
4. Prepare you equipment
Consult with your pool builder or local professional dealer about proper winterization for your
pool equipment. This may involve partial draining, plugging lines, and equipment removal and
storage. If you use antifreeze to protect your pool lines or equipment be sure to use antifreeze
approved for pool use. Do not use automotive anti-freeze.
5. Cover the pool
A well designed cover will keep your pool protected and free from leaves, dirt, and other
debris during the winter months. Solid covers should be free of holes and held in place
securely by water tubes or cables. Add about 2 inches of water to the top of the cover to help
hold it in place. Mesh covers may also be used but will allow rain and some material to enter
the pool during the winter. Apply an additional treatment of Winter Shock and Winter
Algaecide about halfway through the winter to help keep the water clean and free from algae. |
|
|
|
| <<< GO BACK |
|
